Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Queen Anne Homeowners
A leak in your ductwork shows up in ways people don’t always connect: a room that never quite gets warm, dust that settles hours after you cleaned, or a faint musty smell when the furnace kicks on. Duct repair and sealing in Queen Anne fixes that loss at the source instead of just cleaning around it. We seal with mastic and mesh, reattach and reroute flex runs, repair damaged metal trunks, and insulate bare sections so your system moves air where it’s supposed to. Our technicians have up to 11 years of experience, and we carry professional-grade equipment that most residential crews don’t. Call (833) 736-3635 for a free estimate and same-day scheduling.
What Our Duct Repair & Sealing Service Includes
We treat duct repair as a diagnostic job, not a patching job. Every visit starts with locating where your system is losing air or where contamination is getting back in, then fixing that spot properly. The work we do covers six specific situations.
Duct Sealing
Duct sealing closes the gaps where conditioned air escapes before it reaches your rooms, and where attic or crawlspace air gets pulled into the system. You need it when some rooms run hot or cold while the thermostat says the house is fine, or when your energy bill climbs without a change in how you use the system. We seal those joints with mastic and reinforcing mesh rather than tape, so the repair holds through the seasonal swings Queen Anne homes go through.

Flex Duct Repair
Flex duct is the corrugated silver run you’ll see in attics and crawlspaces, and it fails in predictable places: crushed bends, separated collars, and stretches that sagged after installation. You need repair when a run is pinched or disconnected, which starves that room of airflow and can pull unfiltered air into the duct. We re-support the sagging sections, reconnect separated collars properly, and replace runs that are torn or crushed beyond a reliable fix.

Metal Duct Repair
Sheet metal trunk lines and plenums loosen at the seams over time, and those gaps can move a surprising amount of air into a basement or attic instead of your living space. You need this when you can feel air moving at a joint, when the seams rattle, or when a section has been dented or crushed during renovation work. We reseal the joints, straighten what can be straightened, and patch or replace the damaged sections.

Duct Insulation
Duct insulation is what keeps air at the temperature it was when it left the furnace or heat pump, especially for runs through unconditioned space. You need it when ducts in an attic or crawlspace are bare, wrapped in failing foil, or sweating in humid weather. We re-wrap exposed runs with proper insulation so the air arrives at the register closer to the temperature the system produced.
Mastic Sealant
Mastic is a brush-on or trowel-applied sealant, and it’s the standard for sealing duct joints because it bonds and stays flexible, unlike cloth or foil tape that dries out and peels. You need it whenever joints, collars, or plenum connections are sealed with tape alone or not sealed at all. We apply mastic and mesh to those connections so the seal doesn’t open up again in a year.
Air Leak Repair
Air leak repair is the hunt for the leaks you can’t see, the ones hiding behind insulation or above ceiling panels. You need it when the system runs long, never quite satisfies the thermostat, or when you’ve had ducts cleaned and contamination comes right back. We use equipment like Abatement Technologies filtration on-site during the work, so debris and contaminants stay contained while we open and repair the system.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
Duct systems are usually built from components made by a handful of manufacturers, and knowing how each one is put together saves time on the diagnostic end. We work with Aprilaire ducting and air quality components regularly and know where their connections and filter housings tend to loosen or leak over time. We also handle Honeywell controls and duct-mounted accessories, which matters when a repair has to work around a damper or sensor already in the system.
Our equipment side leans on Guardsman and Abatement Technologies gear for containment and air quality work during repairs, so the job stays clean while the ducts are open. We’re careful about one thing: we’re not a manufacturer’s dealer, and we don’t claim to stock OEM parts. What we do is diagnose the failure, repair or replace the section properly, and tell you honestly whether a factory part is worth the wait or a standard replacement will do. Whether you have Aprilaire or Honeywell components in the system or any other make, we can help. For a full system evaluation before repairs, see our air duct cleaning in Queen Anne service.
Signs You Need Duct Repair & Sealing Right Now
Duct problems rarely announce themselves. They show up as patterns. These are the ones worth acting on.
- Rooms that never match the thermostat. If the bedroom runs five degrees off from the living room no matter what you set, a disconnected or crushed duct run is a common cause. It usually means air is dumping into the attic or crawlspace instead of the room.
- Dust returning within days of cleaning. Fresh dust settling quickly after a cleaning points to a leak pulling unfiltered air into the system from a dirty space. That’s a duct repair issue, not a cleaning issue.
- A musty or stale smell when the system starts. Smell at startup usually means the system is drawing air from a damp crawlspace or attic through an opening that shouldn’t be there. Sealing the leak stops the source rather than masking it.
- Higher energy bills with no other explanation. Leaky ducts lose conditioned air before it reaches your rooms, so the system runs longer to hit the same temperature. It’s one of the quieter ways a home wastes money.
- Visible sagging, tape peeling, or crushed flex runs. If you’ve been in the attic or crawlspace and seen ducts sagging between hangers or tape curling off the joints, that’s a repair waiting to get worse. It’s worth addressing before a run comes loose entirely.
Our Duct Repair & Sealing Process – Step by Step
The process is built so you know what’s happening at every stage and why the price is what it is.
- 1
System inspection. We walk the accessible ductwork, noting crushed runs, failed tape, disconnected collars, and bare sections. We also look at the equipment end, since a leak at the plenum changes the whole repair plan.
- 2
Diagnosis and written estimate. We explain what we found and what it will take to fix it, then give you a written estimate. One flat price per system is agreed before any work starts, so there’s no surprise line item once we’re on site.
- 3
Containment and preparation. Before opening anything, we set up filtration so debris and contaminants stay where they belong. This is the step where professional equipment matters, because most residential crews work without containment at all.
- 4
Repair and sealing. We repair or replace the damaged runs, reconnect collars, apply mastic and mesh to joints, and re-insulate exposed sections. If the system needs cleaning or sanitizing alongside the repair, we handle that in the same visit rather than sending you to a second contractor.
- 5
Verification and before-and-after photos. We check airflow at the registers and confirm the seals hold, then show you before-and-after photos of your own ducts. You see what changed, not just what we say changed. If you want the repair combined with a full duct repair & sealing evaluation of the whole system, we’ll map it out in one visit.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Queen Anne?
Duct repair and sealing in Queen Anne typically runs $350-$1,400 depending on how much of the system needs work. A single disconnected flex run with a resealed collar is usually at the lower end. A whole-house sealing job with multiple failed joints, re-insulated runs, and a damaged plenum connection lands higher.
| Job type | Typical cost range |
|---|---|
| Single flex run reconnection | $150-$350 |
| Air leak repair at joints and collars | $250-$600 |
| Mastic sealing of multiple connections | $350-$800 |
| Metal duct repair or section replacement | $400-$1,100 |
| Duct insulation of exposed runs | $300-$900 |
| Full-system repair and sealing | $800-$1,400 |
What pushes a job toward the top of the range is access, not complexity. Ducts buried in tight crawlspaces or run behind finished ceilings take longer to reach and repair properly. The number of failed connections matters too, as does whether the system needs cleaning or sanitizing at the same time. Avoiding overpayment comes down to one thing: get a written, itemized estimate that names what’s being sealed or replaced, and don’t accept per-vent pricing that leaves the total open-ended. Our free estimate covers the inspection, the diagnosis, and the written price. The estimate sets the final price, and we show before-and-after photos once the work is done. Call (833) 736-3635.
Duct Repair & Sealing Near Queen Anne – Our Service Area
We serve Queen Anne and the surrounding neighborhoods, including Magnolia, Fremont, Wallingford, Ballard, Crown Hill, Greenwood, Green Lake, Ravenna, Laurelhurst, Capitol Hill, and Madison Park. Same-day scheduling is available and dispatch runs Sunday through Friday, 7am to 7pm. If you’re outside those neighborhoods, call and we’ll confirm coverage. For neighboring areas, we also offer duct repair & sealing and duct repair & sealing services.
Serving Queen Anne, WA – Our Local Coverage Area
We serve Queen Anne and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Queen Anne
Duct repair and sealing is the process of fixing physical damage to ductwork and closing the gaps where air escapes or contamination enters. It covers reconnecting or replacing damaged runs, resealing joints with mastic, re-insulating exposed ducts, and repairing metal trunks. It’s the step that comes after cleaning, because cleaning a system with open leaks just lets dirt back in.
Most residential jobs take two to four hours, depending on how many connections need work and how accessible the ductwork is. A single disconnected run can be under an hour. A whole-house sealing job with attic and crawlspace work takes longer. A system that also needs cleaning or sanitizing is usually scheduled as one longer visit.
Typical jobs run $350-$1,400, with single-run repairs at the low end and full-system sealing near the top. Access, the number of failed connections, and whether insulation needs replacing are the main factors. The written estimate sets the final price, and it’s free. Call (833) 736-3635 for an exact quote – estimates are free.
Yes, we work with Aprilaire and Honeywell duct components and air quality accessories regularly, and we know where those connections tend to loosen. We’re not a dealer and we don’t claim to stock OEM parts, so if a repair needs a specific factory component we’ll tell you honestly. Whether you have Aprilaire, Honeywell, or another make, we can help.
Same-day scheduling is available, and dispatch runs Sunday through Friday, 7am to 7pm. We’re closed Saturday. We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Workmanship on our duct repair and sealing is backed by our satisfaction guarantee, which covers the sealing and repair work we performed. The local professional performing the work is licensed and insured as their state requires. We explain exactly what the guarantee covers in your written estimate before any work begins, so there’s no ambiguity afterward.
Clear access to the attic hatch, crawlspace entry, and any closet where the air handler sits. That’s the main thing. Move stored items away from those openings so we can work without moving your belongings. Beyond that, nothing special is needed. We set up containment and filtration on arrival, and we walk you through findings before any repair starts.
Schedule Your Duct Repair & Sealing Service in Queen Anne Today
Leaky ducts cost you comfort and money every month they stay unsealed, and the fix is one visit. We inspect the system, give you a written estimate, and repair it properly with mastic, mesh, and professional-grade equipment. One flat price per system, before-and-after photos of your own ducts, and a satisfaction guarantee. Call (833) 736-3635 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You can also read about our duct repair & sealing work in neighboring areas.
Written by the team at Air Duct Cleaning Queen Anne.